Not applicable
Jan 20, 2016
07:22 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 20, 2016
07:22 AM
I'm using DAVE4.1.4 and working on connecting several IOs to EVENT_DETECTORS
When using the HW Signal Connection dialog box, after selecting PIN for the source signal, I do not see the Event Detector APP in the pull down list.
Example is using the Relax Lite Kit where Button 1 and Button 2 are configured for pins 1.14 and 1.15 respectively.
Button_1 doesn't show the APP where Button 2 does.
Are there restriction that are not documented on which Pins can be used?
When using the HW Signal Connection dialog box, after selecting PIN for the source signal, I do not see the Event Detector APP in the pull down list.
Example is using the Relax Lite Kit where Button 1 and Button 2 are configured for pins 1.14 and 1.15 respectively.
Button_1 doesn't show the APP where Button 2 does.
Are there restriction that are not documented on which Pins can be used?
1 Reply
Not applicable
Jan 20, 2016
09:06 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 20, 2016
09:06 AM
HI,
Please refer to the reference manual of the XMC4500 device.
The inputs supported by the External Request Unit (ERU) are listed below. P1.15 is a supported input for the ERU.
P1.14 is not a supported input for the ERU and thus is not selectable in DAVE.
See picture below:
Regards,
Daryl
Please refer to the reference manual of the XMC4500 device.
The inputs supported by the External Request Unit (ERU) are listed below. P1.15 is a supported input for the ERU.
P1.14 is not a supported input for the ERU and thus is not selectable in DAVE.
See picture below:
Regards,
Daryl