Oct 27, 2015
01:28 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 27, 2015
01:28 PM
2 Replies
Nov 04, 2015
01:45 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 04, 2015
01:45 AM
Hello,
Are you using a custom board or the XC866 Easy kit?
With the latter, the device can be programmed through the on-board USB-UART Bridge Controller without the need for a miniWiggler.
Regards,
Min Wei
Are you using a custom board or the XC866 Easy kit?
With the latter, the device can be programmed through the on-board USB-UART Bridge Controller without the need for a miniWiggler.
Regards,
Min Wei
Nov 04, 2015
02:40 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 04, 2015
02:40 AM
Hello,
Thanks for your reply. I am using a bare SAF-XC866-4FRI chip connected to a power supply. I want to program chip before
connecting to board. Thanks.
Feyi Asgill
Thanks for your reply. I am using a bare SAF-XC866-4FRI chip connected to a power supply. I want to program chip before
connecting to board. Thanks.
Feyi Asgill