Not applicable
Oct 27, 2015
04:28 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 27, 2015
04:28 AM
2 Replies
Not applicable
Nov 01, 2015
07:33 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 01, 2015
07:33 PM
Hi,
The purpose mentioned is to count the number of rising edges of an external PWM signal, this is using the CCU as a counter.
If you have DAVE v4 installed, you can use the COUNTER APP to assist you for this purpose. In a Usage section for the APP HELP documentation, you can follow the steps to set up the example to count event edges by the COUNTER APP. In the example the COUNTER APP will count 300000 edges of the counter input.
Regards,
Daryl
The purpose mentioned is to count the number of rising edges of an external PWM signal, this is using the CCU as a counter.
If you have DAVE v4 installed, you can use the COUNTER APP to assist you for this purpose. In a Usage section for the APP HELP documentation, you can follow the steps to set up the example to count event edges by the COUNTER APP. In the example the COUNTER APP will count 300000 edges of the counter input.
Regards,
Daryl
Not applicable
Nov 01, 2015
11:25 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 01, 2015
11:25 PM
Thanks for your response. It is working fine