Not applicable
Oct 14, 2015
05:38 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 14, 2015
05:38 AM
2 Replies
Oct 14, 2015
08:40 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 14, 2015
08:40 PM
Hello,
Can you check that the following settings are correct?
- PCR.MSLSEN = 1 to enable CS generation
- PCR.SELCTR = 1 to use direct select mode though it is also possible to use the other coded select mode
- PCR.SELO = 2 to select SELO1 which is required for P3.3.
Additionally the polarity also needs to be configured with PCR.SELINV but this should not cause CS not to be generated.
Regards,
Min Wei
Can you check that the following settings are correct?
- PCR.MSLSEN = 1 to enable CS generation
- PCR.SELCTR = 1 to use direct select mode though it is also possible to use the other coded select mode
- PCR.SELO = 2 to select SELO1 which is required for P3.3.
Additionally the polarity also needs to be configured with PCR.SELINV but this should not cause CS not to be generated.
Regards,
Min Wei
Not applicable
Nov 05, 2015
02:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 05, 2015
02:49 AM
Thanks, Min Wei for the help, I am still having doubt for ChipSelect. What values we supposed to insert in chip select table if I want to use SELO 0?