Not applicable
Oct 09, 2015
10:20 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 09, 2015
10:20 PM
Hi,
I am working on XMC4100 Controller, i want to test whether controller is in hibernate mode or not How Could we confirm that the controller is in hibernate mode?? i was tried to do the following method
In HDCR Register there is HIB which request to enter into Hibernate mode which i was set.
now how could i confirm that Controller is Entered Into Hibernate mode???
Thanks and Regards.
I am working on XMC4100 Controller, i want to test whether controller is in hibernate mode or not How Could we confirm that the controller is in hibernate mode?? i was tried to do the following method
In HDCR Register there is HIB which request to enter into Hibernate mode which i was set.
now how could i confirm that Controller is Entered Into Hibernate mode???
Thanks and Regards.
2 Replies
Oct 13, 2015
12:42 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 13, 2015
12:42 AM
In Hibernate mode the power supply to the core is switched off. Additionally the power to the analog domain and the main supply VDDP can be switched off. Onlythe Hibernate power domain will stay powered.
Therefore I don't think you can run your debugger and most of your peripheral will be down at this moment. These can be used as indication for hibernate mode.
Therefore I don't think you can run your debugger and most of your peripheral will be down at this moment. These can be used as indication for hibernate mode.
Not applicable
Oct 14, 2015
04:32 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 14, 2015
04:32 AM
Thanks for Reply