Not applicable
Sep 24, 2015
11:08 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 24, 2015
11:08 AM
Hi there,
I collect data from IIC transmission into FIFO on the XMC1100 and try to read after complete reception with a 'for' loop into an array. Obviously the loop is too fast for the FIFO. I can only get all data if I add a loop to reduce speed.
Is there a better way to handle this?
Thanks,
I collect data from IIC transmission into FIFO on the XMC1100 and try to read after complete reception with a 'for' loop into an array. Obviously the loop is too fast for the FIFO. I can only get all data if I add a loop to reduce speed.
Is there a better way to handle this?
Thanks,
2 Replies
Sep 27, 2015
09:28 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 27, 2015
09:28 PM
Hello,
Is the 'for' loop started only after all the data are received in the FIFO? If so, it should not be a problem.
Regards,
Min Wei
Is the 'for' loop started only after all the data are received in the FIFO? If so, it should not be a problem.
Regards,
Min Wei
Not applicable
Oct 06, 2015
09:07 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 06, 2015
09:07 AM
Hello,
thanks for your response. I will check this. I may not have payed enough attention to the fact that I use a very slow baudrate.
thanks for your response. I will check this. I may not have payed enough attention to the fact that I use a very slow baudrate.