How to Set Boot Mode Index using Serial Wire Debug Protocol

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Not applicable
Greetings,
sir/madam i am working on serial wire debug protocol. I was implemented serial wire debug protocol, which was successfully tested for used controllers like xmc1100,xmc4500..etc, when i tried to Access the control on newer controller it is not taking the SWD commands by searching on internet i notified by one point that if the controller is with ASC_BSL as boot mode index we can't access, we must change the BMI value to SWD0 in order to access with serial wire debug protocol, i am not getting how to change the Boot mode index could you please tell me how can i change BMI to SWD0 manually by using SWD protocol??
0 Likes
2 Replies
Travis
Employee
Employee
First solution authored Welcome! 500 replies posted
Hi,

BMI setting is only applicable to XMC1000 family. You can read and change the BMI via the DAVE4 environment.
0 Likes
Not applicable
Thank you for Reply
0 Likes