Not applicable
Sep 24, 2015
05:41 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 24, 2015
05:41 AM
Greetings,
sir/madam i am working on serial wire debug protocol. I was implemented serial wire debug protocol, which was successfully tested for used controllers like xmc1100,xmc4500..etc, when i tried to Access the control on newer controller it is not taking the SWD commands by searching on internet i notified by one point that if the controller is with ASC_BSL as boot mode index we can't access, we must change the BMI value to SWD0 in order to access with serial wire debug protocol, i am not getting how to change the Boot mode index could you please tell me how can i change BMI to SWD0 manually by using SWD protocol??
sir/madam i am working on serial wire debug protocol. I was implemented serial wire debug protocol, which was successfully tested for used controllers like xmc1100,xmc4500..etc, when i tried to Access the control on newer controller it is not taking the SWD commands by searching on internet i notified by one point that if the controller is with ASC_BSL as boot mode index we can't access, we must change the BMI value to SWD0 in order to access with serial wire debug protocol, i am not getting how to change the Boot mode index could you please tell me how can i change BMI to SWD0 manually by using SWD protocol??
2 Replies
Sep 30, 2015
07:57 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 30, 2015
07:57 PM
Hi,
BMI setting is only applicable to XMC1000 family. You can read and change the BMI via the DAVE4 environment.
BMI setting is only applicable to XMC1000 family. You can read and change the BMI via the DAVE4 environment.
Not applicable
Oct 08, 2015
03:55 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 08, 2015
03:55 AM
Thank you for Reply