Not applicable
Aug 20, 2015
10:19 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 20, 2015
10:19 PM
Hi,
I successfully built a program for UART in DAVE but I'm unable to find UART serial port in my device manager. I have installed J-link CDC serial port driver but to no avail.
Moreover, Jlink configuration wizard says that "connected debug probe does not support VCOM functionality. Kindly help me out.
I successfully built a program for UART in DAVE but I'm unable to find UART serial port in my device manager. I have installed J-link CDC serial port driver but to no avail.
Moreover, Jlink configuration wizard says that "connected debug probe does not support VCOM functionality. Kindly help me out.
1 Reply
Not applicable
Aug 24, 2015
08:20 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 24, 2015
08:20 PM
HI,
Unfortunately, VCOM through the OBD (on-board debugger) is not supported on the XMC4500 Relax Kit. 😞
Please refer to the following forum entry:
http://www.infineonforums.com/threads/832-DAVE-TIP-of-the-day-xSPY-solution-for-XMC-kits
http://www.infineonforums.com/threads/2257-Communicate-with-XMC4500-relax-lite-kit-v1-over-usb?
Regards,
Daryl
Unfortunately, VCOM through the OBD (on-board debugger) is not supported on the XMC4500 Relax Kit. 😞
Please refer to the following forum entry:
http://www.infineonforums.com/threads/832-DAVE-TIP-of-the-day-xSPY-solution-for-XMC-kits
http://www.infineonforums.com/threads/2257-Communicate-with-XMC4500-relax-lite-kit-v1-over-usb?
Regards,
Daryl