Aug 13, 2015
01:01 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 13, 2015
01:01 PM
4 Replies
Not applicable
Aug 16, 2015
11:31 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 16, 2015
11:31 PM
Hi there,
Your memory structure has been set in the linker_script.ld file in main project directory. That is total flash size. If you want to see the used flash, you can refer to map file which shows all the addresses of Flash and RAM used while flashing the code.
The total flash size in XMC4500 is 2 MB, including 1MB cached and 1MB uncached Flash.
Hope it helped.
Regards
Your memory structure has been set in the linker_script.ld file in main project directory. That is total flash size. If you want to see the used flash, you can refer to map file which shows all the addresses of Flash and RAM used while flashing the code.
The total flash size in XMC4500 is 2 MB, including 1MB cached and 1MB uncached Flash.
Hope it helped.
Regards
Aug 19, 2015
02:39 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 19, 2015
02:39 PM
Hi Saqiba,
XMC4500 has two versions of flash size (768KB and 1024KB).
I need to detect by code . I can detect the size by reading FLASH0_ID?
thank you
XMC4500 has two versions of flash size (768KB and 1024KB).
I need to detect by code . I can detect the size by reading FLASH0_ID?
thank you
Aug 27, 2015
12:05 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 27, 2015
12:05 AM
No. FLASH0_ID register does not have this information.
Aug 27, 2015
12:12 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 27, 2015
12:12 AM
Your software is only specific to a particular XMC4000, hence it should take note of this.