Not applicable
May 26, 2015
09:27 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 26, 2015
09:27 AM
Hi,
I am a new user with Infineon XMC mcu,
I have .hex and want to use J-Link for uploading hex file to my target board with my own xmc1302.
I connected Vref, SWDIO, SWCLK and GND from J-Link to VCC(+5V), SWD(P0.14), SWCLK(P0.15) and GND in my target board.
but It can NOT connect success in debuging of DAVE4.
I even try using XMC1300 boot kit with same connecting pin, it also failed.
so I want to ask is that connecting of pin correct ?
please give me a hint, Thank you so much!
I am a new user with Infineon XMC mcu,
I have .hex and want to use J-Link for uploading hex file to my target board with my own xmc1302.
I connected Vref, SWDIO, SWCLK and GND from J-Link to VCC(+5V), SWD(P0.14), SWCLK(P0.15) and GND in my target board.
JLink VS Target
Vref <-> +5V
SWDIO <-> SWD(P0.14)
SWCLK <-> SWCLK(P0.15)
GND <-> GND
but It can NOT connect success in debuging of DAVE4.
J-Link is connected.
Firmware: J-Link V9 compiled Apr 21 2015 18:10:40
Hardware: V9.30
S/N: xxxxxxxxx
OEM: SEGGER-EDU
Feature(s): FlashBP, GDB
Checking target voltage...
Target voltage: 5.14 V
Listening on TCP/IP port 2331
Connecting to target...ERROR: Could not connect to target.
Target connection failed. GDBServer will be closed...Restoring target state and closing J-Link connection...
Shutting down...
I even try using XMC1300 boot kit with same connecting pin, it also failed.
so I want to ask is that connecting of pin correct ?
please give me a hint, Thank you so much!
1 Reply
Not applicable
Jun 04, 2015
08:40 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 04, 2015
08:40 PM
Hi,
I tried on the XMC1300 boot kit and was able to connect.
For your test, did you use the USB to power your target board. If so, please ensure that there are sufficient current to supply your target board from the USB.
Regards,
Daryl
I tried on the XMC1300 boot kit and was able to connect.
For your test, did you use the USB to power your target board. If so, please ensure that there are sufficient current to supply your target board from the USB.
Regards,
Daryl