Not applicable
Mar 18, 2015
06:12 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 18, 2015
06:12 AM
Hello,
I use Dave 3.1.10 to configure my XMC4500F144 controller. I use a thrid party RTOS with IP-Stack, so I dont want the App with IP-Stack.
I added the ETH001 app, which includes also the ETH002 app.
Then I select the MII Interface in the Mac Interface Selection in app ETH001.
The I start the solver.
So far so good.
When I want to manually assign the pins (by right click on the ETH001 app and manual pin assignment) I can only assign two RX and two TX pins. But for the MII Interface I do need 4 connections in each direction.
Am I missing something?
Thanks for your help!
I use Dave 3.1.10 to configure my XMC4500F144 controller. I use a thrid party RTOS with IP-Stack, so I dont want the App with IP-Stack.
I added the ETH001 app, which includes also the ETH002 app.
Then I select the MII Interface in the Mac Interface Selection in app ETH001.
The I start the solver.
So far so good.
When I want to manually assign the pins (by right click on the ETH001 app and manual pin assignment) I can only assign two RX and two TX pins. But for the MII Interface I do need 4 connections in each direction.
Am I missing something?
Thanks for your help!
Labels
2 Replies
Not applicable
Mar 20, 2015
03:47 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 20, 2015
03:47 AM
Hi,
Thank you very much for the feedback. A change request (eTicket #982654345) has been submitted.
Best regards,
Sophia
Thank you very much for the feedback. A change request (eTicket #982654345) has been submitted.
Best regards,
Sophia
Not applicable
Jul 27, 2016
09:07 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 27, 2016
09:07 AM
sophia wrote:
Hi,
Thank you very much for the feedback. A change request (eTicket #982654345) has been submitted.
Best regards,
Sophia
We had changed the PHY from KSZ8031RNL (RMII) to KSZ8041NL(RMII or MII). Are there support for MII mode available?