XMC4500 Ethernet with MII interface

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Not applicable
Hello,

I use Dave 3.1.10 to configure my XMC4500F144 controller. I use a thrid party RTOS with IP-Stack, so I dont want the App with IP-Stack.

I added the ETH001 app, which includes also the ETH002 app.
Then I select the MII Interface in the Mac Interface Selection in app ETH001.
The I start the solver.
So far so good.

When I want to manually assign the pins (by right click on the ETH001 app and manual pin assignment) I can only assign two RX and two TX pins. But for the MII Interface I do need 4 connections in each direction.

Am I missing something?

Thanks for your help!
0 Likes
2 Replies
Not applicable
Hi,

Thank you very much for the feedback. A change request (eTicket #982654345) has been submitted.

Best regards,
Sophia
0 Likes
Not applicable
sophia wrote:
Hi,

Thank you very much for the feedback. A change request (eTicket #982654345) has been submitted.

Best regards,
Sophia


We had changed the PHY from KSZ8031RNL (RMII) to KSZ8041NL(RMII or MII). Are there support for MII mode available?
0 Likes