Not applicable
Sep 03, 2012
10:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 03, 2012
10:58 AM
I am using an XE167G and the Dave tool to initialise its PLL so that the system clock frequency is 5.78MHz (its a port over job). The START_V3.a66 created sets _WSFLASH to zero, which in its own comments suggest that this is illegal. Also the data sheet indicates that this value should not be used. If in Dave I select a clock frequency of 66MHz _WSFLASH remains at zero!
For this device is _WSFLASH allowed to be zero? If not how should it be determined?
Also I am using the XE167F DIP file with Dave which was the closes to an XE167G that I could find. Is this OK?
Regards
Farmer Jones
For this device is _WSFLASH allowed to be zero? If not how should it be determined?
Also I am using the XE167F DIP file with Dave which was the closes to an XE167G that I could find. Is this OK?
Regards
Farmer Jones
Labels
- Tags:
- IFX
0 Replies