Not applicable
Nov 20, 2014
09:29 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 20, 2014
09:29 AM
2 Replies
Not applicable
Nov 21, 2014
12:09 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 21, 2014
12:09 AM
Hi Roger,
There is no error or your understanding is incorrect.
The ASC bootloader indeed is P1.4 and P1.5, however, the XMC4400 application kit is it not designed to have the on-board debugger to support the bootloader interface.
Therefore, you can select the boot mode via the dip switch and you have to make your own interface to P1.4 and P1.5.
The pin P1.5 and P1.7 are pins for USIC 0 as well.
So, UART communication will be supported by the on-board debugger.
There is no error or your understanding is incorrect.
The ASC bootloader indeed is P1.4 and P1.5, however, the XMC4400 application kit is it not designed to have the on-board debugger to support the bootloader interface.
Therefore, you can select the boot mode via the dip switch and you have to make your own interface to P1.4 and P1.5.
The pin P1.5 and P1.7 are pins for USIC 0 as well.
So, UART communication will be supported by the on-board debugger.
Not applicable
Nov 21, 2014
01:28 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 21, 2014
01:28 AM
Hello Jackson,
I understand thank you. Maybe it would have been useful had the 6 pin connector been connected to the UART boot pins.
Thanks Roger
I understand thank you. Maybe it would have been useful had the 6 pin connector been connected to the UART boot pins.
Thanks Roger