Not applicable
Oct 08, 2014
11:19 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 08, 2014
11:19 PM
Hey guys
I need suggestions please:
I have 4 dc motors fitted to the underside of a portable platform.
These motors must engage on my command then turn the "worm gear" that will in turn lower the stabilizer arms to level out the platform.
I am looking for a micro controller that can be programmed to do this.
I know this will most probably not be a quick fix thing but am willing to learn, no rush.
Please advise
Thanks in advance
I need suggestions please:
I have 4 dc motors fitted to the underside of a portable platform.
These motors must engage on my command then turn the "worm gear" that will in turn lower the stabilizer arms to level out the platform.
I am looking for a micro controller that can be programmed to do this.
I know this will most probably not be a quick fix thing but am willing to learn, no rush.
Please advise
Thanks in advance
- Tags:
- IFX
2 Replies
Oct 08, 2014
11:52 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 08, 2014
11:52 PM
Hi,
I assume the motors are simple 12V brushed dc motors?
Best Regards
Jurgen
I assume the motors are simple 12V brushed dc motors?
Best Regards
Jurgen
Not applicable
Oct 09, 2014
10:46 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 09, 2014
10:46 PM
Hi, apologies, a bit off in a rush posting there 🙂 .
Yes these are dc brush motors. Only need to engage em so that i can up and down em, but will use some relay logic for main power supply to the motor (So the micro will only operate the relay contacts) .
Yes these are dc brush motors. Only need to engage em so that i can up and down em, but will use some relay logic for main power supply to the motor (So the micro will only operate the relay contacts) .