Not applicable
Aug 28, 2014
08:48 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 28, 2014
08:48 AM
I have configured instance 5 of the PWMSP002 App with the Direct Output Pin Configuration disabled.
However, after running the solver the Resource Mapping shows the direct output connected to P1.4 (which it had been previously). See below...
Any comments would be most welcome.
Best regards
Aaron
However, after running the solver the Resource Mapping shows the direct output connected to P1.4 (which it had been previously). See below...
Any comments would be most welcome.
Best regards
Aaron
3 Replies
Not applicable
Sep 02, 2014
02:15 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 02, 2014
02:15 AM
Hi Aaron,
Did the problem happen in a newly created project in DAVE 3.1.10?
Best regards,
Sophia
Did the problem happen in a newly created project in DAVE 3.1.10?
Best regards,
Sophia
Not applicable
Sep 02, 2014
02:18 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 02, 2014
02:18 AM
Hi Sophia,
The problem occurred in a project migrated from 3.1.6 to 3.1.10. It is the ACB2 project I have sent you in the past.
Best regards
Aaron
The problem occurred in a project migrated from 3.1.6 to 3.1.10. It is the ACB2 project I have sent you in the past.
Best regards
Aaron
Not applicable
Sep 11, 2014
01:38 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 11, 2014
01:38 AM
Hi Sophia,
This problem disappeared after upgrading to the latest DAVE libraries.
Best regards
Aaron
This problem disappeared after upgrading to the latest DAVE libraries.
Best regards
Aaron