Not applicable
Jul 01, 2014
04:08 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 01, 2014
04:08 AM
I would like to set / clear the PWMSP002 'Enable Single Shot Mode' at run time but there does not appear to be an API function to do this.
Is there a recommended method for doing this ?
Any suggestions would be greatly appreciated.
Best regards
Aaron
Is there a recommended method for doing this ?
Any suggestions would be greatly appreciated.
Best regards
Aaron
- Tags:
- IFX
2 Replies
Not applicable
Jul 01, 2014
11:48 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 01, 2014
11:48 PM
Hi Aaron,
Are you looking for CC8yTC.TSSM bit? For example, use "CCU80_CC80 -> TC |= 0x02" to enable Single Shot Mode.
BR,
Zain
Are you looking for CC8yTC.TSSM bit? For example, use "CCU80_CC80 -> TC |= 0x02" to enable Single Shot Mode.
BR,
Zain
Not applicable
Jul 02, 2014
12:15 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 02, 2014
12:15 AM
Hi Zain,
That is exactly what I need. Once again thank you very much for your help.
Best regards
Aaron
That is exactly what I need. Once again thank you very much for your help.
Best regards
Aaron