Not applicable
Jun 02, 2014
01:39 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 02, 2014
01:39 AM
Hi There,
We have designed Solenoid driver using attached schematic, which contains BTS716G and BTS3118N.
Please review it and comment if you find any faults. After your approval we will proceed further.
We have designed Solenoid driver using attached schematic, which contains BTS716G and BTS3118N.
Please review it and comment if you find any faults. After your approval we will proceed further.
Labels
2 Replies
Jun 17, 2014
12:50 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 17, 2014
12:50 AM
Hi,
We see a 4-channel high side power switch with nominal current 2.6A (BTS716G) and a current limit of 6.5A and low side power switches (designed for 12V appplication) with nominal current 2.17A (BTS3118N) and current limit of 10A. The low side switches will enable connection of solenoid to GND. SOL_CUR_N_x nets will probably be used for voltage level measurement. You have free wheeling diodes D2-D5 and fuses in the output pathes of high side switch. You will control inputs of high side switch by PWM signal.
Are you using the external solenoid SOL1 as connected in this schematic or will it be connected to nets SOL_OUT_P_1 and SOL_OUT_N_1 (behind fuse and resistor)? Schematics seems to be ok.
Please inform about your prototype and tests.
We see a 4-channel high side power switch with nominal current 2.6A (BTS716G) and a current limit of 6.5A and low side power switches (designed for 12V appplication) with nominal current 2.17A (BTS3118N) and current limit of 10A. The low side switches will enable connection of solenoid to GND. SOL_CUR_N_x nets will probably be used for voltage level measurement. You have free wheeling diodes D2-D5 and fuses in the output pathes of high side switch. You will control inputs of high side switch by PWM signal.
Are you using the external solenoid SOL1 as connected in this schematic or will it be connected to nets SOL_OUT_P_1 and SOL_OUT_N_1 (behind fuse and resistor)? Schematics seems to be ok.
Please inform about your prototype and tests.
Not applicable
Apr 08, 2015
09:11 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 08, 2015
09:11 AM
Sorry for the mistake, Solenoid be connected to nets SOL_OUT_P_1 and SOL_OUT_N_1 as you said.