ccu8/1/cc8/3 is not selectable as a manual resource assignment in PWMSP002

[#1]

Target is XMC4504-F100x512.
From the data sheet I believe ccu slice 3 does exists in ccu8 module 1

[#2]

Hi Doug,

The PWMSP002 is constrained by the Max. resource requirement of Asymmetric PWM. The pins assignment are restricted to OUTy0, OUTy1.
OUTy2 and OUTy3 are not available.
This has been highlighted in Forum thread "PWM output on xmc4500 pin P5.1 (CCU81.OUT32) ?" 8-Jul post.

Best regards,
Sophia