Not applicable
May 20, 2014
07:50 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 20, 2014
07:50 AM
1 Reply
Not applicable
May 21, 2014
12:42 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 21, 2014
12:42 AM
Hi Doug,
Is the project a newly built? Are you using 2x NVIC002[1.0.26] for interrupt signal connections?
Can you try to:
1) remove the existing NVIC Apps --> generate the code (optional)
2) add 2x NVIC002 Apps --> add signal connections --> generate the code
You should be able to get following code in multiplexer.c (just an example):
Best regards,
Sophia
Is the project a newly built? Are you using 2x NVIC002[1.0.26] for interrupt signal connections?
Can you try to:
1) remove the existing NVIC Apps --> generate the code (optional)
2) add 2x NVIC002 Apps --> add signal connections --> generate the code
You should be able to get following code in multiplexer.c (just an example):
// Configuring CCU40_CC40SRS = Service Request Selector
WR_REG(CCU40_CC40->SRS, CCU4_CC4_SRS_CMSR_Msk, CCU4_CC4_SRS_CMSR_Pos, CCU_SR2);
// Configuring CCU41_CC40SRS = Service Request Selector
WR_REG(CCU41_CC40->SRS, CCU4_CC4_SRS_POSR_Msk, CCU4_CC4_SRS_POSR_Pos, CCU_SR1);
Best regards,
Sophia