Not applicable
May 20, 2014
05:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 20, 2014
05:58 AM
I have a unique case of needing to use a CCU slice as a timer, but not connect it to an output or input pin.
Usually I would use a PWMSP001 app and not assign a pin.
However, DAVE does not allow the creation of a CCU based app if there is not a free CCU available that can be linked to a free pin.
It would be great to have a hardware timer app that can use available CCUs but does not require an available pin.
The system timer can not be used in my use case since it is used by the RTOS at a higher lower resolution.
Usually I would use a PWMSP001 app and not assign a pin.
However, DAVE does not allow the creation of a CCU based app if there is not a free CCU available that can be linked to a free pin.
It would be great to have a hardware timer app that can use available CCUs but does not require an available pin.
The system timer can not be used in my use case since it is used by the RTOS at a higher lower resolution.
1 Reply
Not applicable
May 21, 2014
02:54 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 21, 2014
02:54 AM
Hi Doug,
Thank you very much for the feedback. I'll help to forward to the responsible person.
Best regards,
Sophia
Thank you very much for the feedback. I'll help to forward to the responsible person.
Best regards,
Sophia