First Programming a brandnew XMC1201

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Not applicable
I made some test on the Evalboard, which works fine. Now I build my own bord and connect the XMC1201 with the debug tool from the Evalbord (only SW Ckl and SWD) but I got an error message, the there isd no device or problems with the debugger. What's going wrong?
Regards
Ewald
0 Likes
1 Reply
Not applicable
Hi, Ewald,

A brand new XMC1201 device, the default BMI is ASC BSL. So, for you to use the debug tool, you need to change the BMI to User mode SWD0/1. Furthermore, I assume you have powered up your own board when connect the SWD and SWD_CLK from the evalboard.
How to change the BMI value, please refer to this thread: http://www.infineonforums.com/threads/1467-XMC1300-boot-kit-debugger-problem?highlight=segger

Regard
tys
0 Likes