Not applicable
Apr 02, 2014
10:00 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 02, 2014
10:00 AM
Hi i'm currently working on interfacing the MPU6050 sensor with XMC4500 RelaxKit and I would like to send data from the XMC to the PC through Serial to visualize if i get the correct readings from the sensor and probably interfacing with Processing to demonstrate the imu working correctly.
So, I would like to know if it this is possible or the only way is by through a RS485 cable connected to pc, and if it is possible which UART pins are connected to the USB cable.
Best regards,
André Morais (uSG)
So, I would like to know if it this is possible or the only way is by through a RS485 cable connected to pc, and if it is possible which UART pins are connected to the USB cable.
Best regards,
André Morais (uSG)
1 Reply
Not applicable
Apr 06, 2014
07:17 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 06, 2014
07:17 PM
Hi André,
There is a app called USBVC001 in DAVE3 and you can use it to create virtual com port when you connect xmc4500 with the PC.
There are some API provided that allows you to send and receive data over the USB to the virtual com port.
So, from your PC, you just need to connect a terminal program to the virtual com port.
rgds,
Rou
There is a app called USBVC001 in DAVE3 and you can use it to create virtual com port when you connect xmc4500 with the PC.
There are some API provided that allows you to send and receive data over the USB to the virtual com port.
So, from your PC, you just need to connect a terminal program to the virtual com port.
rgds,
Rou