On-Board CAN Transcievers XC2768X-136F128L Kit connections problem

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Not applicable
Hi all,

I am just trying to check the functionality of the two CAN on-board transcievers.These two CAN transceiver are connected to the MultiCAN on XC2000 node 0 and 1. The transceivers are connected on the Kit to two IDC10 plugs. I connected these two transcievers using two jumper wires i.e CAN1L to CAN2L and CAN1H to CAN2H. When I programmed the chip to send the typed characters using serial interface through these CAN transcievers to be displayed on the screen and also an LED P10.0 should be toggled.But when I debuged the code, neither the LED blinks nor I see anything on the Hyperterminal.The have synchronised the settings of hyperterminal with the ASC.When I don't use the CAN bus transcievers, then the serial interface just alone works fine.
Can anybody suggest me some solution to this?
0 Likes
1 Reply
Not applicable
Hi mmehdi98,

The connection is possible with the 2 jumper wire as how you connected.
So most probably is the configuration of the MultiCAN that makes your CAN communication not working.
Can you please specify your details configuration or upload your project here?
Perhaps I can help you take a look and troubleshoot for you.
0 Likes