XMCFlasher verify

[User19304]

Hello
I am using XMCFlasher and XMC1300 bootkit to program XMC1202-0032

I execute the following sequence :
change BMI to SWD0
erase
program with the hex file
reset the power supply
verify

XMCFlasher gives verify successfull, (file checksum is equal with memory checksum)

But if I save the memory content to my PC and compare with the hex file I programmed , they are different.
I run again the verify command on XMCFlasher software
I still get verify successfull

[Alakananda_BG · Accepted solution]

Hi,

The default location goes to the address AAA since while reading the device, it reads all the flash location and also may be the hexfile is not overwriting the complete flash.

Regards