Sep 08, 2021
05:36 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 08, 2021
05:36 AM
Hi,
I have encountered a problem with debug.
I launched Debug As
DAVE C/C++ Application
The error message was very cryptic and did not help in finding the solution.
The error message is as follows:
After looking into the problem I realised that the missing file is not mentioned in the Debug Configurations window in the field of C/C++ Application.
See in the attachment below:
The solution is to add the file in the field see bellow:
I hope this helps if you have the same problem.
Greetings
I have encountered a problem with debug.
I launched Debug As
DAVE C/C++ Application
The error message was very cryptic and did not help in finding the solution.
The error message is as follows:
After looking into the problem I realised that the missing file is not mentioned in the Debug Configurations window in the field of C/C++ Application.
See in the attachment below:
The solution is to add the file in the field see bellow:
I hope this helps if you have the same problem.
Greetings
Solved! Go to Solution.
- Tags:
- IFX
1 Solution
Sep 08, 2021
11:54 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 08, 2021
11:54 PM
Hi,
Thanks for sharing your solution with community. This normally happens when you have created a debug configuration before building the project. This will be automatically added if project is build first.
You can also create another debug configuration by double clicking on GDB SEGGER J-Link Debugging on left side.
Best Regards,
Vasanth
Thanks for sharing your solution with community. This normally happens when you have created a debug configuration before building the project. This will be automatically added if project is build first.
You can also create another debug configuration by double clicking on GDB SEGGER J-Link Debugging on left side.
Best Regards,
Vasanth
1 Reply
Sep 08, 2021
11:54 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 08, 2021
11:54 PM
Hi,
Thanks for sharing your solution with community. This normally happens when you have created a debug configuration before building the project. This will be automatically added if project is build first.
You can also create another debug configuration by double clicking on GDB SEGGER J-Link Debugging on left side.
Best Regards,
Vasanth
Thanks for sharing your solution with community. This normally happens when you have created a debug configuration before building the project. This will be automatically added if project is build first.
You can also create another debug configuration by double clicking on GDB SEGGER J-Link Debugging on left side.
Best Regards,
Vasanth