Aug 25, 2021
09:20 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 25, 2021
09:20 AM
We observed that our code is working correctly with debugger.
It rotates motor correctly.
But when we remove debugger it doesnt Working. Motor does not rotate.
Current 20 mA is consumed and Voltage i have measured are as follow without debugger
Input votage 12 v
VDDC 1.5V
VDEXT 5V
VDPP 5V
VCP 12 V
and with debugger also hving same voltage level except VCP it has 12+14=26v.
It rotates motor correctly.
But when we remove debugger it doesnt Working. Motor does not rotate.
Current 20 mA is consumed and Voltage i have measured are as follow without debugger
Input votage 12 v
VDDC 1.5V
VDEXT 5V
VDPP 5V
VCP 12 V
and with debugger also hving same voltage level except VCP it has 12+14=26v.
2 Replies
Sep 05, 2021
11:22 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 05, 2021
11:22 PM
Hello Roshan,
we executing code in debugger mode the watchdog is disabled.
Therefore I assume you are facing SW problems with your code.
Can you observe resets at the RESET pin?
Best,
Fiz
we executing code in debugger mode the watchdog is disabled.
Therefore I assume you are facing SW problems with your code.
Can you observe resets at the RESET pin?
Best,
Fiz
Sep 13, 2021
05:06 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 13, 2021
05:06 AM
Yes, I observed reset pin is having constant 5v