May 28, 2021
12:02 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 28, 2021
12:02 AM
Hi all,
I just received my BLDC Shield TLE9879, and I'm wondering what is the easiest way to connect power, phases, and hall sensors?
I can simply solder the power & phases wires to the screw mounts, but if there's a more "clean" way of connecting it, I'd prefer that.
Regarding the hall sensors, I thought of using socket headers on the hall sensors wires coming out of the motor.
What do you guys think?
Regards,
Shay
I just received my BLDC Shield TLE9879, and I'm wondering what is the easiest way to connect power, phases, and hall sensors?
I can simply solder the power & phases wires to the screw mounts, but if there's a more "clean" way of connecting it, I'd prefer that.
Regarding the hall sensors, I thought of using socket headers on the hall sensors wires coming out of the motor.
What do you guys think?
Regards,
Shay
Labels
2 Replies
May 31, 2021
03:36 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 31, 2021
03:36 AM
Hi Shay,
great to hear, that you are using our BLDC shield!
Soldering the wires zo VBAT and GND is the best way to go. You could also use crocodile clamps.
For hall sensors, you can connect the cables from the motor to the socket headers.
What kind of motor are you using in your project?
Best,
Fiz
great to hear, that you are using our BLDC shield!
Soldering the wires zo VBAT and GND is the best way to go. You could also use crocodile clamps.
For hall sensors, you can connect the cables from the motor to the socket headers.
What kind of motor are you using in your project?
Best,
Fiz
May 31, 2021
07:22 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 31, 2021
07:22 AM
Fiz wrote:
Hi Shay,
great to hear, that you are using our BLDC shield!
Soldering the wires zo VBAT and GND is the best way to go. You could also use crocodile clamps.
For hall sensors, you can connect the cables from the motor to the socket headers.
What kind of motor are you using in your project?
Best,
Fiz
Hi Fiz,
Thank you for the quick response.
I'm using QBL4208-41-04-006 by Trinamic.