May 19, 2021
03:12 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 19, 2021
03:12 AM
Hi,
I am trying for UART communication with IMC101T-T038 to start the motor. But i cannot connect start the motor.
1) I can start/stop the motor with Infineon MCEdesigner.
2)As i read in forum that by editing .txt parameter exported from Infineon MCEwizard.
edited Interfacecong0 to 1,
systaskconfig to 58,
UART0_Baudrate tried with 15200 & also 9609.
3) Tried to load it to the IMC101T-T038, always end with the following errors.
4) I have attemped with those 4sec count.
5) i request some1 counld spot a light to overcome this problem.
Thank you
I am trying for UART communication with IMC101T-T038 to start the motor. But i cannot connect start the motor.
1) I can start/stop the motor with Infineon MCEdesigner.
2)As i read in forum that by editing .txt parameter exported from Infineon MCEwizard.
edited Interfacecong0 to 1,
systaskconfig to 58,
UART0_Baudrate tried with 15200 & also 9609.
3) Tried to load it to the IMC101T-T038, always end with the following errors.
4) I have attemped with those 4sec count.
5) i request some1 counld spot a light to overcome this problem.
Thank you
Labels
- Tags:
- IFX
1 Reply
Jun 07, 2021
04:04 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 07, 2021
04:04 PM
Hello Vinay6217,
There is no need to mess with txt file manually, Use MCEWizard to enable user uart protocol. Refer to SRM UART. Index, 2.3.
https://www.infineon.com/dgdl/Infineon-MCESW-RM-UserManual-v01_03-EN.pdf?fileId=5546d462719b59230171...
Sid
There is no need to mess with txt file manually, Use MCEWizard to enable user uart protocol. Refer to SRM UART. Index, 2.3.
https://www.infineon.com/dgdl/Infineon-MCESW-RM-UserManual-v01_03-EN.pdf?fileId=5546d462719b59230171...
Sid