Working with BGT24LTR11N16

Announcements

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
User11520
Level 2
Level 2
10 replies posted 10 questions asked 5 replies posted
Hello everyone,
I am trying to work with the BGT24LTR11N16 board but without positive outcome. I connected VCC, VCC_PTAT and TX_ON to 3.3V bias, whereas GND, V_CTRL to gnd.
I am sure that the transceiver is transmitting because I observe the 24 GHz signal on my spectrum analyzer. However, at both IFI and IFQ I read only a continuous signal, 1.5 V, of course also in presence of movements.
Do you know what I am doing wrong?
Thanks in advance
0 Likes
1 Solution
User11520
Level 2
Level 2
10 replies posted 10 questions asked 5 replies posted
I solved the issue.
The amplification at intermediate frequency was too low. Now it works.

View solution in original post

0 Likes
1 Reply
User11520
Level 2
Level 2
10 replies posted 10 questions asked 5 replies posted
I solved the issue.
The amplification at intermediate frequency was too low. Now it works.
0 Likes