May 07, 2021
06:24 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 07, 2021
06:24 AM
Hello everyone,
I am trying to work with the BGT24LTR11N16 board but without positive outcome. I connected VCC, VCC_PTAT and TX_ON to 3.3V bias, whereas GND, V_CTRL to gnd.
I am sure that the transceiver is transmitting because I observe the 24 GHz signal on my spectrum analyzer. However, at both IFI and IFQ I read only a continuous signal, 1.5 V, of course also in presence of movements.
Do you know what I am doing wrong?
Thanks in advance
I am trying to work with the BGT24LTR11N16 board but without positive outcome. I connected VCC, VCC_PTAT and TX_ON to 3.3V bias, whereas GND, V_CTRL to gnd.
I am sure that the transceiver is transmitting because I observe the 24 GHz signal on my spectrum analyzer. However, at both IFI and IFQ I read only a continuous signal, 1.5 V, of course also in presence of movements.
Do you know what I am doing wrong?
Thanks in advance
Solved! Go to Solution.
- Tags:
- IFX
1 Solution
May 11, 2021
01:33 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 11, 2021
01:33 AM
I solved the issue.
The amplification at intermediate frequency was too low. Now it works.
The amplification at intermediate frequency was too low. Now it works.
1 Reply
May 11, 2021
01:33 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 11, 2021
01:33 AM
I solved the issue.
The amplification at intermediate frequency was too low. Now it works.
The amplification at intermediate frequency was too low. Now it works.