Apr 06, 2021
03:38 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 06, 2021
03:38 PM
I am running a lower power BLDC 4-pole motor using the TLE9879 Arduino Bridge in standalon mode now. I have had the motor working will when running the Arduino using the bridge, but am now having problems migrating parameters that worked on the Arduino Shield over to the Eval board. I have hooked up J-Scope, and as the controller enters state 3 (closed loop mode), it stalls out. When I observe ActSpeedDisplay, I see the speed converge on the RefSpeed. However, the motor is completely stalled. I am figuring that the broken parameters lie in the sensing of the RPM using BEMF. I am trying to determine where to change these. Are there guidance on the parameters implemented in the Config Wizard?
Labels
- Tags:
- IFX
1 Reply
Apr 16, 2021
06:32 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 16, 2021
06:32 PM
Hi
Try to change the BEMF and Speed filter time in ConfigWizard.
Try to change the BEMF and Speed filter time in ConfigWizard.