+ Reply to Thread
Results 1 to 1 of 1

Thread: BEMF Parameters in Sensorless FOC application

  1. #1
    New Member New Member zcab911 is on a distinguished road
    Join Date
    Mar 2021
    Posts
    1
    Points
    30

    BEMF Parameters in Sensorless FOC application

    I am running a lower power BLDC 4-pole motor using the TLE9879 Arduino Bridge in standalon mode now. I have had the motor working will when running the Arduino using the bridge, but am now having problems migrating parameters that worked on the Arduino Shield over to the Eval board. I have hooked up J-Scope, and as the controller enters state 3 (closed loop mode), it stalls out. When I observe ActSpeedDisplay, I see the speed converge on the RefSpeed. However, the motor is completely stalled. I am figuring that the broken parameters lie in the sensing of the RPM using BEMF. I am trying to determine where to change these. Are there guidance on the parameters implemented in the Config Wizard?
    Last edited by zcab911; Apr 6th, 2021 at 03:40 PM.

+ Reply to Thread
Disclaimer

All content and materials on this site are provided “as is“. Infineon makes no warranties or representations with regard to this content and these materials of any kind, whether express or implied, including without limitation, warranties or representations of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, whether express or implied, is granted by Infineon. Use of the information on this site may require a license from a third party, or a license from Infineon.


Infineon accepts no liability for the content and materials on this site being accurate, complete or up- to-date or for the contents of external links. Infineon distances itself expressly from the contents of the linked pages, over the structure of which Infineon has no control.


Content on this site may contain or be subject to specific guidelines or limitations on use. All postings and use of the content on this site are subject to the Usage Terms of the site; third parties using this content agree to abide by any limitations or guidelines and to comply with the Usage Terms of this site. Infineon reserves the right to make corrections, deletions, modifications, enhancements, improvements and other changes to the content and materials, its products, programs and services at any time or to move or discontinue any content, products, programs, or services without notice.