Apr 04, 2021
04:02 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 04, 2021
04:02 PM
Hi,
I'm trying to use the DAP_MINIWIGGLER with a 10-pin connector. After I connected it to my laptop, I tried to measure the voltage between pin 3&5 using a DMM and it was 0V, then measured the voltage between pin 3&1 and it was also 0V ... according to my understanding it should be 5V ! Also I didn't notice any LED on after I connected the miniwiggler to the USB ! ... is this normal, or I have a malfunctioning DAP miniwiggler?
Also, I'd appreciate if I can get the schematic of the "KIT_DAP_MINIWIGGLER_USB"
Thanks,
Nour
I'm trying to use the DAP_MINIWIGGLER with a 10-pin connector. After I connected it to my laptop, I tried to measure the voltage between pin 3&5 using a DMM and it was 0V, then measured the voltage between pin 3&1 and it was also 0V ... according to my understanding it should be 5V ! Also I didn't notice any LED on after I connected the miniwiggler to the USB ! ... is this normal, or I have a malfunctioning DAP miniwiggler?
Also, I'd appreciate if I can get the schematic of the "KIT_DAP_MINIWIGGLER_USB"
Thanks,
Nour
Solved! Go to Solution.
- Tags:
- IFX
1 Solution
Nov 30, 2021
12:57 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 30, 2021
12:57 AM
Hi Nour,
Kinldy refer the following document.
https://www.infineon.com/dgdl/AP2400314_DAP_Connector.pdf?fileId=db3a3043183a9555011888ea09bf671b
Best Regards,
Vasanth
1 Reply
Nov 30, 2021
12:57 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 30, 2021
12:57 AM
Hi Nour,
Kinldy refer the following document.
https://www.infineon.com/dgdl/AP2400314_DAP_Connector.pdf?fileId=db3a3043183a9555011888ea09bf671b
Best Regards,
Vasanth