Jan 13, 2021
11:10 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 13, 2021
11:10 AM
All:
I have searched available info about the GTM, and I think this can be done, but I need to know how.
I read a PWM waveform using TIM0, and I want to recreate the waveform on an output: PWM -> TIM -> TOM -> PWM
The output does not need to be in phase, but I need to know if it can be done.
Does it involve the ARU?
Can it involve the SPE?
Also, we are in an MCAL environment, so the setup is done via Tresos and ported to Tasking, finally downloaded onto a target board.
Thanks in advance,
Todd Anderson
I have searched available info about the GTM, and I think this can be done, but I need to know how.
I read a PWM waveform using TIM0, and I want to recreate the waveform on an output: PWM -> TIM -> TOM -> PWM
The output does not need to be in phase, but I need to know if it can be done.
Does it involve the ARU?
Can it involve the SPE?
Also, we are in an MCAL environment, so the setup is done via Tresos and ported to Tasking, finally downloaded onto a target board.
Thanks in advance,
Todd Anderson
0 Replies