Not applicable
Jun 14, 2012
01:01 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 14, 2012
01:01 AM
4 Replies
Jun 14, 2012
02:30 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 14, 2012
02:30 AM
I remember a few years back I did something like that. If you go into the Help file of FLOAD, there is a very brief description. You need to make a UART to CAN bridge. I used a XC800 easy kit board without the XC800 and I hardwired the UART RxD/TxD to the CAN transceiver TxD/RxD. Then I used FLOAD in UART protocol Half Duplex mode. The FLOAD Help file on Page 9, section 4.5 gives you the CAN Transceiver Interface.
Have you tried this? Basically, this is just a UART BSL sending over a CAN bus.
Have you tried this? Basically, this is just a UART BSL sending over a CAN bus.
Not applicable
Jun 14, 2012
03:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 14, 2012
03:31 AM
Thanks. The question was related to another one of mine.
Problem solved. I was not able to comunicate with the controller due to external oscillator.
There was no frequency, hence the controller was continuous in Reset.
Problem solved. I was not able to comunicate with the controller due to external oscillator.
There was no frequency, hence the controller was continuous in Reset.
Jun 14, 2012
06:26 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 14, 2012
06:26 PM
Ok, understood 🙂 You are using the method described in the help file?
Not applicable
Jun 17, 2012
10:17 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 17, 2012
10:17 PM
Yes, the stept in the help example.
BSL TMS on '0', RESET on '1' with FLOAD program.
Grüsse.
BSL TMS on '0', RESET on '1' with FLOAD program.
Grüsse.