Dec 31, 2020
08:06 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 31, 2020
08:06 PM
Hi,
I'm using a XMC1100 microcontroller. I want to program this controller without using Jlink.I need to flash it by only using RX and TX connection .is it possible?
Thanks and Regard in Advance
I'm using a XMC1100 microcontroller. I want to program this controller without using Jlink.I need to flash it by only using RX and TX connection .is it possible?
Thanks and Regard in Advance
Solved! Go to Solution.
Labels
- Labels:
-
Technical Center
- Tags:
- IFX
1 Solution
Jan 20, 2022
08:13 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 20, 2022
08:13 PM
Hi,
Check the following appnote: https://www.infineon.com/dgdl/Infineon-TOO_XMC1000_Boot_Modes-ApplicationNotes-v01_04-EN.pdf?fileId=...
Best Regards,
Vasanth
1 Reply
Jan 20, 2022
08:13 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 20, 2022
08:13 PM
Hi,
Check the following appnote: https://www.infineon.com/dgdl/Infineon-TOO_XMC1000_Boot_Modes-ApplicationNotes-v01_04-EN.pdf?fileId=...
Best Regards,
Vasanth