Dec 21, 2020
12:21 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 21, 2020
12:21 AM
Hi,
by configuring the ANGLE_BASE (register MOD3) with the value 0x800, it happens quite randomly that the error "Invalid angle value" bit12 of SAFETY WORD is generated.
This has happened in one unit after about 100 programmed without problems. If I change the ANGLE_BASE value to 0x7FF or 0x801 the issue doesn't happen.
Could it be a problem of this unit only or am I doing something wrong?
Thank you!
Regards.
by configuring the ANGLE_BASE (register MOD3) with the value 0x800, it happens quite randomly that the error "Invalid angle value" bit12 of SAFETY WORD is generated.
This has happened in one unit after about 100 programmed without problems. If I change the ANGLE_BASE value to 0x7FF or 0x801 the issue doesn't happen.
Could it be a problem of this unit only or am I doing something wrong?
Thank you!
Regards.
1 Reply
Mar 23, 2021
01:49 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 23, 2021
01:49 PM
Привет MotterliniM! как твои дела? Ñ‚Ñ‹ решил Ñвой вопроÑ?