Dec 16, 2020
11:45 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 16, 2020
11:45 PM
Hello, i have some questions about dps422 pressure sensor. Can i use sensor in high precision mode(5cm) without using FIFO? I wrote code for that mode, but sensor doesn't work in 5cm all the time. In continuous measurement mode,
when sensor finish one measurement (for example pressure oversampling 104ms+temperature oversampling 27ms=131ms , and rate 4 sample per sec=250ms) does he go to stand by mode for 250-131=119ms or i must write control
bits for stand by for that time, and after 119ms(for example) again put him in continuous measurement mode ? Thank you 😘 Regards
when sensor finish one measurement (for example pressure oversampling 104ms+temperature oversampling 27ms=131ms , and rate 4 sample per sec=250ms) does he go to stand by mode for 250-131=119ms or i must write control
bits for stand by for that time, and after 119ms(for example) again put him in continuous measurement mode ? Thank you 😘 Regards
- Tags:
- IFX
0 Replies