Dec 02, 2020
05:26 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 02, 2020
05:26 AM
Hello,
I use the product TLE5012B_E1000_MS2GO and have a problem with the SSC.
I start the GUI and set SPI, but nothing happens there. The Auto Detected Log says:
SSC IF Not Active,
Active Interface: not known,
Key parameters: -not available.
How can I activate the SSC or where exactly is the problem?
I measure MOSI,MISO,CLK but no SPI Signal is there.
Here is the Eval Manual:
http://www.farnell.com/datasheets/2700284.pdf
Many thanks for the help!
I use the product TLE5012B_E1000_MS2GO and have a problem with the SSC.
I start the GUI and set SPI, but nothing happens there. The Auto Detected Log says:
SSC IF Not Active,
Active Interface: not known,
Key parameters: -not available.
How can I activate the SSC or where exactly is the problem?
I measure MOSI,MISO,CLK but no SPI Signal is there.
Here is the Eval Manual:
http://www.farnell.com/datasheets/2700284.pdf
Many thanks for the help!
0 Replies