Nov 24, 2020
06:44 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 24, 2020
06:44 PM
hello,
To test the Sense2GOL in use of Infineon tool box, I have been following the instruction of Sense2GOL kit by downloading all the according files - Infineon tool box and JLINK USB Driver
However, at the step of selecting debugger type I cannot choose "SEGGER" which does not appears in the drop-down menu. only "DAP" is available.
What i have checked so far:
- USB connection for Sense2GOL is properly set
- Sense2GOL works fine.
- uC-Probe-XMC works well.
Could you please how to solve this issue?
To test the Sense2GOL in use of Infineon tool box, I have been following the instruction of Sense2GOL kit by downloading all the according files - Infineon tool box and JLINK USB Driver
However, at the step of selecting debugger type I cannot choose "SEGGER" which does not appears in the drop-down menu. only "DAP" is available.
What i have checked so far:
- USB connection for Sense2GOL is properly set
- Sense2GOL works fine.
- uC-Probe-XMC works well.
Could you please how to solve this issue?
1 Reply
Nov 26, 2020
02:02 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 26, 2020
02:02 AM
Hello,
What is the version of XMC Flasher tool that you use? If it is not the latest one, please install the latest version using Infineon Toolbox (https://www.infineon.com/cms/en/tools/landing/infineontoolbox.html) and try again.
If you are already using the latest version of XMC Flasher, please share the log messages from XMC Flasher with us (Log (menu) -> Show Log).
Thanks and Regards,
Sudheesh
What is the version of XMC Flasher tool that you use? If it is not the latest one, please install the latest version using Infineon Toolbox (https://www.infineon.com/cms/en/tools/landing/infineontoolbox.html) and try again.
If you are already using the latest version of XMC Flasher, please share the log messages from XMC Flasher with us (Log (menu) -> Show Log).
Thanks and Regards,
Sudheesh