Oct 29, 2020
01:50 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 29, 2020
01:50 AM
Hi
Thank you very much for designing the IC controller IMC102T-F064.
I configured this IC to start the Motor with PFC using UART connection.
I have no problem starting the Motor, but when I put the input control on VSP, the Motor starts but the power factor correction (PFC) does not start.
How can I start control input mode VSP, both motor and power factor correction(PFC) in input mode?
Should the power factor correction(PFC) command be given in the script? (PFC_command=1)?
Thank you.
Thank you very much for designing the IC controller IMC102T-F064.
I configured this IC to start the Motor with PFC using UART connection.
I have no problem starting the Motor, but when I put the input control on VSP, the Motor starts but the power factor correction (PFC) does not start.
How can I start control input mode VSP, both motor and power factor correction(PFC) in input mode?
Should the power factor correction(PFC) command be given in the script? (PFC_command=1)?
Thank you.
Labels
- Tags:
- IFX
2 Replies
Nov 06, 2020
08:09 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 06, 2020
08:09 AM
Hello Mahdi1368,
There is no built-in logic to link VSP with the operation of PFC. One needs to write up some script code to make it happen for a given application.
Some pseudo code for example.
If command = 1
Then PFC_command=1
Else
PFC_command=0
Regard,
Sid
There is no built-in logic to link VSP with the operation of PFC. One needs to write up some script code to make it happen for a given application.
Some pseudo code for example.
If command = 1
Then PFC_command=1
Else
PFC_command=0
Regard,
Sid
Nov 10, 2020
12:16 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 10, 2020
12:16 AM
Thanks for reply 🙂