Oct 09, 2020
05:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 09, 2020
05:14 AM
1 Reply
Oct 19, 2020
04:50 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 19, 2020
04:50 PM
Hi Kit,
MCEWizard 2.3 was updated but control of an induction motor remains possible. In MCEWizard you can still set the control mode to Voltage Control in the Options section. To select open loop angle, you use MCEDesigner to set the AngleSelect register to 0. MCEDesigner also provides a VF Diagnostic function in the Motor window. AngleSelect is set to 0 for open loop control and CtrlModeSelect to 0 for voltage control mode under this function. You can use Script also as described in the AN.
MCEWizard 2.3 was updated but control of an induction motor remains possible. In MCEWizard you can still set the control mode to Voltage Control in the Options section. To select open loop angle, you use MCEDesigner to set the AngleSelect register to 0. MCEDesigner also provides a VF Diagnostic function in the Motor window. AngleSelect is set to 0 for open loop control and CtrlModeSelect to 0 for voltage control mode under this function. You can use Script also as described in the AN.