Sep 22, 2020
04:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 22, 2020
04:58 AM
I hvae just bought Distance2Go kit and installed infineon toolbox (radar gui and XMC flasher).
When I connect Distance2Go main board(bigger side) and open radar gui, there always shows an pop up window with "unknown error".
I'm preety sure I have installed the driver and toolbox correctly.
Could anybody provide any advice to solve this problem?
I will appricate if your can help. Thanks.
When I connect Distance2Go main board(bigger side) and open radar gui, there always shows an pop up window with "unknown error".
I'm preety sure I have installed the driver and toolbox correctly.
Could anybody provide any advice to solve this problem?
I will appricate if your can help. Thanks.
Labels
2 Replies
Sep 24, 2020
08:06 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 24, 2020
08:06 AM
Hello dadairen1hao,
Please try these steps:
1) Install the Distance2Go Kit from the toolbox.
2) Open the ReadMe.txt located in .\Firmware_Software\Binary in the Distance2Go directory to decide which of the 4 firmware hex images you are interested in. If you are not sure start with D2G_Doppler_FMCW.hex.
3) Then download the Distance2Go firmware image you have selected from .\Firmware_Software\Binary to the Distance2Go board. This will make sure the version of firmware in the board is compatible with the RADAR GUI version you are using.
4) Unplug the USB cable and reconnect it to restart the board.
Please try these steps:
1) Install the Distance2Go Kit from the toolbox.
2) Open the ReadMe.txt located in .\Firmware_Software\Binary in the Distance2Go directory to decide which of the 4 firmware hex images you are interested in. If you are not sure start with D2G_Doppler_FMCW.hex.
3) Then download the Distance2Go firmware image you have selected from .\Firmware_Software\Binary to the Distance2Go board. This will make sure the version of firmware in the board is compatible with the RADAR GUI version you are using.
4) Unplug the USB cable and reconnect it to restart the board.
Sep 28, 2020
08:17 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 28, 2020
08:17 AM
Thank you for the answer. Have already solved it.