Sep 18, 2020
06:18 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 18, 2020
06:18 AM
Hi,
I've just started using my Distance2Go kit, the GUI interface tells me to update the firmware but I have not been able to find the file to FLASH into the board.
Where is the updated firmware hex file for the Distance2Go board?
Thanks.
I've just started using my Distance2Go kit, the GUI interface tells me to update the firmware but I have not been able to find the file to FLASH into the board.
Where is the updated firmware hex file for the Distance2Go board?
Thanks.
Solved! Go to Solution.
1 Solution
Sep 21, 2020
12:45 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 21, 2020
12:45 AM
Hi Monika,
Please refer to the folder IFX_D2G-HW-SW_V2.0.x\Firmware_Software\Binary, there you will find different .hex files for different FW configurations running on the D2G board.
You can use the XMC Flasher, available tool from the Infineon Toolbox (installed with your Distance2Go Kit).
Best Regards,
Montassar
1 Reply
Sep 21, 2020
12:45 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 21, 2020
12:45 AM
Hi Monika,
Please refer to the folder IFX_D2G-HW-SW_V2.0.x\Firmware_Software\Binary, there you will find different .hex files for different FW configurations running on the D2G board.
You can use the XMC Flasher, available tool from the Infineon Toolbox (installed with your Distance2Go Kit).
Best Regards,
Montassar