XMC4800 EtherCAT Product_Code and Revision_Number change

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
User20173
Level 2
Level 2
First solution authored
Hi,

Base on the XMC48_ECAT project,
I open SSC to change some of the default parameters of the board.
Vendor_ID I got from Beckhoff, Product_Code=1, Revision_Number=2 etc.

All files are generated, including XML with new values and the eeprom.h with new codes in the array.

But as soon as I run the program over Dave debugger, and connect the board to Twincat, I see the same values as before, just default ones.
It looks like the eeprom was not upload by Dave debug configuration.

How to do this?
0 Likes
2 Replies
User20173
Level 2
Level 2
First solution authored
4583.attach4582.attach4584.attach

Added pictures to illustrate the problem.
Twincat warning message still shows 0x0 for both values when re-run the board from Dave debugger, despite the fact that SSC generated 0x1 and 0x2 in eeprom.h
0 Likes
User20173
Level 2
Level 2
First solution authored
I have found how to do this over the Ethernet card, using SSC->Tools.
Can close the thread, thank you )))
0 Likes