Aug 14, 2020
02:26 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 14, 2020
02:26 AM
Hi,
I posted this issues on the XMC Forum a few days ago, but since I haven't received any responses, I figured I might have posted in the wrong forum, so I'll here as well (btw, I'm very new this forum and products).
I just bought an OPTIGA Trust XMC 4800 IoT Connectivity Kit, and have just started going through some tutorials, such as for DAVE.
There's a DAVE QuickStart Guide for how to make a LED blink using a generated PWM signal. I follow the instructions, and have tried to use both the
"XMC4800 IoT Connectivity Kit" under Boards, as well as the XMC4800-F100x2048" under the "XMC4800 Series" option, but in both cases neither P4.0 nor P4.1
are available when I try to assign the PWM output (these are LED pins on the board). Has anyone encountered the same problem?
Thanks!
I posted this issues on the XMC Forum a few days ago, but since I haven't received any responses, I figured I might have posted in the wrong forum, so I'll here as well (btw, I'm very new this forum and products).
I just bought an OPTIGA Trust XMC 4800 IoT Connectivity Kit, and have just started going through some tutorials, such as for DAVE.
There's a DAVE QuickStart Guide for how to make a LED blink using a generated PWM signal. I follow the instructions, and have tried to use both the
"XMC4800 IoT Connectivity Kit" under Boards, as well as the XMC4800-F100x2048" under the "XMC4800 Series" option, but in both cases neither P4.0 nor P4.1
are available when I try to assign the PWM output (these are LED pins on the board). Has anyone encountered the same problem?
Thanks!
- Tags:
- IFX
1 Reply
Aug 17, 2020
02:51 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 17, 2020
02:51 AM
Hi,
Pins P4.0 (LED1) or P4.1(LED2) are not connected to any of the CCUx slices therefore you will not be able to toggle these pins using the PWM APP.
You can try using the system timer instead.
Regards,
Jesus
Pins P4.0 (LED1) or P4.1(LED2) are not connected to any of the CCUx slices therefore you will not be able to toggle these pins using the PWM APP.
You can try using the system timer instead.
Regards,
Jesus