Xmc4200 hrpwm

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
User19988
Level 1
Level 1
Hello,

in the XMC4200 user manual in chapter 20 page 15 you can read about ressources of fail safe monitor.
What are these ressources?
to get a little bit more specific on my case:
I'd like to increase the duty cycle of a switch mode power supply in PCC mode after the start of the controller slowly until it reaches the duty cycle needed for the steady state.
My thought was to clear the low resolution part with the compare signal of the HRPWM and increase this compare signal over time, but unfortunatly thats not possible because i cant connect these two in the HW signal connections overview
I hope somebody can help me.
0 Likes
0 Replies