GTM TIM Channel Mode - to detect the rising and falling edge

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
DSRnathan
Level 3
Level 3
50 sign-ins 25 replies posted 25 sign-ins
Hello All,
I am trying to using GTM - TIM capture channel to detect the rising and falling edge of the incoming PWM wave or signal. i started using TIM Input Event Mode(TIEM) for counting the incoming edges. But I also wanted to record timestamp of each edge detection.
Kindly can anyone help me out , How to record the timestamp of each detected active edge(rising or falling).

Kind regards,
Deepak
0 Likes
0 Replies